Home
 Products
 Other Products...
 New: devFoam 3
 New: devWing Foam 2
 New: devSim Cnc Foam
 devFus Foam 2
 devCnc Foam
 devWing Foam
 Download
 Tutorials
 F.A.Q.
 Requirements
 Prices and Purchasing
 Customer Support
 Upgrade
 Partners
 Usb key
 New: Forum!
 Privacy



  

DevWing Foam:  Sides Shaping cutting: Foam block placement

 


In the fifth step of the Cutting Project you will specify the placement of the Foam block on the cutting table for the Side Shaping cutting. The Side Shaping cutting is a separate cutting job that will cut the root/tip sides of each block at the right size and angle.
 
 
You can also check the 2D preview as seen from the left/right sides

 

You can view the 3D simulation of the cut of all blocks, to verify if all the cutting job works the way you like. This time you can see also the carriages cutting paths:

 


Back to devWing Foam main page
Home  |  Forum  |  Contact   
Copyright 2006/2024 - All rights reserved - P.IVA n.00860190255 info@devcad.com